Clutch Set
Hover over the image to zoom in
Share this:

Beck/Arnley Clutch Set

Part No. 061-9240 Warranty Details  

See if this part fits a specific vehicle.

Check Vehicle Fit

Clutch sets come with all components needed for the application. General installation tips provided will help but are not intended to replace a service manual.
Back To Top
Alignment Tool Included:Yes
Clutch Disc Diameter:240 mm
Disc Diameter:240 mm
Input Shaft Diameter:25.4 mm
Pilot Bushing Included:Yes
Release Bearing Included:Yes

Do you have questions about this product?


Ask a question, get answers from real customers and in-house experts. For further assistance, please review your support options on our Contact Us page.

1 Question | 1 Answer
Displaying question 1
  • Q:

    My clutch goes to the floor with no effort wont connect to shift gears. It started when got a flat that put the car at an angle. Was fine before the tire went. Do you think I need an adjustment or a need clutch?
    Asked on 4/24/2012 by Anonymous from augusta,ga

    1 answer



      Check with your clutch master and slave cylinder. It may be low on fluid and/or has air in the lines. Have somebody to push the clutch in and you watch to see if the pin pushes the throwout lever enough to completely disengage the clutch as it should. The slave cylinder should move about 1/2 an inch. Align the clutch disc with alignment tool. Even after these adjustments, if the problem continues then the clutch has to be replaced.

      Answered on 4/27/2012 by Vincent from AAP
Displaying question 1

Do you have a question about this product? 

Check out the specials in our monthly flyer.
Disclaimer We strive to keep all information accurate and up-to-date; however, product availability, pricing, promotions and store hours are subject to change without notice. Please contact Customer Care if you have any questions or corrections.