item(s) totaling $
See if this part fits a specific vehicle.
|This product doesnt fit any of your saved vehicles||Check Fit for another vehicle|
Do you have questions about this product?
Ask a question, get answers from real customers and in-house experts. For further assistance, please review your support options on our Contact Us page.
Q:I have a 2002 dodge neon se and need to know if the motor mount on the drivers side can be installed without moving the engine.
A:Follow the procedure given below to replace the moor mount on your 2002 Dodge Neon SE. Disconnect the negative battery terminal if the engine mount on which you are working is close to the cooling fan for the engine. Even if the car is turned off, the fan can still be turned out automatically by the engine's computer, which could cause serious harm if you are caught in the way of the fan's rotation. Place a floor jack underneath your 2002 Dodge Neon engine and jack it up so that it is supporting some of the weight of your engine. Do not jack up the engine so much that it begins to lift the engine itself, but just so that it begins to support the weight of the motor. Placing the floor jack in the center of the engine will give the jack the best balance for supporting the engine. You can also place a 1/2 inch piece of plywood underneath the oil pan to help disperse the force of the floor jack over a wider surface area when jacking up the engine. Undo the three bolts that are holding the engine mount into place on your 2002 Dodge Neon. When you pull out the middle bolt, a steel bar will drop down. Make sure that your feet are not directly beneath the fall line for the steel rod. Remove the center bolt, which is the final bolt connecting the engine to the center of the mount. Standing on the driver's side of the mount will enable you to get the clearance that you need to pull out the bolt. Use your socket wrench with a 15 millimeter socket adapter and a 4-inch extension to get to the bolt. Use your socket wrench to unscrew and remove the two vertical mount insulator fasteners from the Dodge Neon's frame rail. Next, remove the purge duty solenoid from the engine mount bracket that you are replacing. Double check your floor jack to make sure that it is still supporting the weight of the engine. If it is not or if it has moved since you first positioned it, that could affect your ability to remount the engine on your new engine mount. Remove the thru-bolt access hole cover. You should be able to pull this off or pry it loose with a screwdriver. Pull out the thru-bolt from the insulator assemble and then remove the insulator. Use the reverse of the above instructions for installing the new engine mount. Use the torque wrench to tighten the new engine mount to the rail fasteners at 40 foot pounds. Tighten the engine mount bracket thru-bolt to 80 foot pounds. Lower the floor jack and your 2002 Dodge Neon should be ready to go. For any further assistance, please visit your nearest Advance Auto store or call us directly at 1-877-ADVANCE (238-2623) and one of our representatives there would be more than happy to assist you.
Q:Do you have to jack up the engine inorder to install this mount?
A:For further assistance regarding the Anchor Mount Engine-Transmission (Part# 2975), please provide the year, make, model and engine size of your vehicle. This information would help us to assist you in a better way.
Q:There is a similar (in appearance) mount on the passenger’s side at the top of the engine. The shaft which extends into these rubber pads has worn or compressed the rubber pads/bumpers so the shaft sits towards the front of the engine compartment. The engine shaft/mount no long sits in the center of these rubber mounts. What is the proper mount to anchor the engine?
A:For further assistance please provide the vehicle's year, make, model, and engine size.
Q:where is this transmission mount located?
A:The transmission mount on your vehicle should be located on the driver side of the engine bay, more towards the back, near the tire.
A:The mount is under the battery holder. You must remove the air filter assembly then the battery pan. The mount is right there.