-
Your Store:
-
See if this part fits a specific vehicle.
| Connector Gender: | Female |
| Terminal Gender: | Male |
REVIEW SNAPSHOT®
by PowerReviewsPros
Cons
Best Uses
REVIEWS
Reviewed by 3 customers
Sort by
Displaying reviews 1-3
Pros
Cons
Best Uses
Comments about BWD Blower Motor Resistor:
replace resistor when replacing motor . resistor is under the motor
Pros
Cons
Best Uses
Comments about BWD Blower Motor Resistor:
worker great replaced old perfectly
Pros
Cons
Best Uses
Comments about BWD Blower Motor Resistor:
good prouduct
Displaying reviews 1-3
Do you have questions about this product?(earn points for answers!)
Ask a question, get answers from real customers and in-house experts. Or contact Customer Care by email or call 1-877-238-2623.
Q:
Where is it located on 1999 Ranger ?1 answer
CUSTOMER CARE
A:
The blower motor resistor on your 1999 Ford Ranger should be located under the hood, in the black electrical box. There is a drawing of all that is in the box in the owner's manual. The blower motor resistor's number should be 9. For any further assistance, please visit your nearest Advance Auto store or call us directly at 1-877-ADVANCE (238-2623) and one of our representative there would be more than happy to assist you.Q:
Where is the resistor located on 2001 Ranger with v6 eng & air? My blower only runs on HI.1 answer
CUSTOMER CARE
A:
It should be located on the right side, rear of engine compartment near blower motor.Q:
I have a 1997 Ford Exployer and the Blower Motor Resistor needs replaced---Where is it located and what does it intail to replace it?1 answer
CUSTOMER CARE
A:
It is located just to the left of the blower motor. Disassemble your blower motor and expose the electronics inside. Inspect the resistors in your blower motor. They are either a small coil with electrical connections or are a removable part of an integrated circuit board. Remove the screws holding the resistor to the board, and then remove the resistor from the motor. Insert the replacement resistor in the same place as the old one and secure it with screws. Ensure that no stray wires or connections are touching the resistor.Q:
i have a 1997 ford ranger where can i find the resistor?2 answers
CUSTOMER CARE
A:
The blower motor resistor should be located under the dash board on the passenger side of the car.A:
It is on the blower motor assembly towards the bottom. Very hard to get to without moving washer fluid container.Q:
I have a 2000 ford ranger with air, fan works on high only i believe relay is the problem, where is it located..walt:::1 answer
CUSTOMER CARE
A:
The blower motor resistor is located under the dash board on the passenger side of the car.Q:
What replacement resistor for heater fan do I need for Olds Toronado Borougham 1985 5.0 gas engine?1 answer
CUSTOMER CARE
A:
Unfortunately, we do not carry a blower motor resister for a 1985 Oldsmobile Toronado Brougham 5.0L 307CI V8. I would recommend visiting a local Advance Auto Parts store where they may be able to special order this part for you.Q:
where is this on a 97 ranger splash?1 answer
CUSTOMER CARE
A:
It will either be behind the control panel or behind the glove box with all the other A\/C components. However with out the presence of your vehicle we cannot provide you with a 100% answer.Q:
where is the resistor located on mr 1998 Ford Explorer1 answer
A:
the resistor is located under the hood under the heater blowerQ:
Where in my 2002 ford ranger truck will I find this resistor?2 answers
CUSTOMER CARE
A:
It will either be behind the control panel or behind the glove box with all the other A/C components.A:
You will find the resistor and pigtail, in the engine compartment to the right and just below the the fan motor onthe air housing. 2 screws hold it on. Easiest way to remove:Q:
I have a 2002 Ranger, 3.0 V-6 with A-C. How do I access this component?1 answer
CUSTOMER CARE
A:
This part could be located on the firewall or in the dashboard.