Thermosteel 2400°F Cold Weld by CarGo Thermosteel (part#18003TRI) / Sealers

Comments about CarGo Thermosteel Thermosteel 2400°F Cold Weld:

Bought this product as a stopgap measure to re-attach an upper heat stove on my small block Chevy exhaust manifold. The upper heat stove on the manifold fell off, I used this to put it back on and it really worked well! I used this product until I get the time to actually take the manifolds off, have them blasted, drill the studs that actually hold the stove on, and have the manifolds coated. I cleaned the rust off the manifold, cleaned the back of the heat stove, and followed the product instructions. So far it is working very well. As a side note I originally used high heat JB weld for this repair, and when I tried to attach the pre heater hose to the stove, it fell off the manifold. This is a great product, and worked for me, highly recommended!

Comments about CarGo Thermosteel Thermosteel 2400°F Cold Weld:

it was easy to use it did take a while to stir its really stuck to the walls and bottom it was kinda runny even after stirring it for like 5 minutes went on runny it gooped off a little after i let it dry for a hour i came back it was like playdoh and i could really move it and fill the cracks and make it nice after exactly 5 hours i started my vehicle for exactly 15 minutes like it says on the bottle and it seems to be working excellent its very tough and doesnt look that bad i give it 4*